Meet the Dual Mode ‘SPEED’ Servo. This servo is essentially the original 2000-0025-0002 ‘TORQUE’ Servo, but with a lower ratio to achieve a quicker transit speed! Over 2x faster than its counterpart, this servo saves valuable time where it counts!
Just like the 25-2, this servo boasts two different modes which allow it to fill a variety of roles on your robot or project. In the default mode, the servo is able to rotate 300 degrees while having positioning feedback. In this mode, the PWM signal will determine the position of the servo. Using the 3102 Series Dual Mode Servo Programmer (1-1) the servo can be toggled into continuous rotation mode. In this mode, the servo will have proportional speed control based on the PWM signal that you send with your servo controller.
2000 Series Dual Mode Servo (25-3, Speed)
Weight 58g Gear Ratio 135:1 Output Shaft Style 25 Tooth Spline Voltage Range 4.8V ~ 7.4V No-Load Speed (4.8V) 0.11 sec/60° (90RPM) No-Load Speed (6.0V) 0.09 sec/60° (115RPM) No-Load Speed (7.4V) 0.07 sec/60° (145RPM) Stall Torque (4.8V) 7.9 kg.cm (110 oz-in) Stall Torque (6.0V) 9.3 kg.cm (130 oz-in) Stall Torque (7.4V) 10.8 kg.cm (150 oz-in) No-Load Current (4.8V) 190mA No-Load Current (6.0V) 200mA No-Load Current (7.4V) 230mA Stall Current (4.8V) 2000mA Stall Current (6.0V) 2500mA Stall Current (7.4V) 3000mA Max PWM Range (Default) 500 - 2500μsec Max PWM Range (Continuous) 1000 - 2000μsec Travel per µsec (Default) 0.15°/μsec Max Travel (Default) 300° Pulse Amplitude 3-5V Direction Clockwise w/ Increasing PWM Signal Deadband Width 4μsec Motor Type Brushed DC Feedback Style 5KΩ Potentiometer Output Shaft Support Dual Ball Bearing Gear Material Steel Wire Length 300mm Wire Gauge 22 AWG Connector Type 3-Pos TJC8 Servo Connector [MH-FC]